Equipment information
Tektronix PG 509 Generator
Manufacturer:
No picture available!
Maybe you can upload a pic for the
Tektronix PG 509 ?
If you have any other manuals for the
Tektronix PG 509 you can upload the files here .
Model:
PG 509
Date:
1989
Category:
Group:
Description:
Pulse Generator
Information
The PG 509 Pulse Generator is a fast-risetime pulse source
producing narrow rectangular pulses at a repetition rate of
50 KHz.The PG 509 can deliver a continuous pulse train at an
amplitude of 25 volts into an output toad of 50 ohms.
The PG 509 Pulse Generator is a TM 500 Series Plug-In
instrument. All functional electronics are included, but it
requires insertion in a TM 500 or TM 5000 Series Power
Module Mainframe for interfacing to basic power supplies.
The PG 509 Pulse Generator was primarily designed to be an
integral part of a test system. Figure 1-1 shows primary
components and connections immediately related to the Pulse
Generator in a typical system. Other than the System
Controller, Device Under Test, and PG 509, these are:
• A programmable attenuator (TEKTRONIX AT 5010, or
equivalent); used to provide system selection for the degree
of attenuation required.
• A high frequency multiplexer/switcher (TEKTRONIX SI 5010,
or equivalent); used to route inputs and outputs between
Instruments and test devices while under system control.
Note that while the PG 509 is not under direct GPIB control,
it is typically directed by instruments that are. In a
mostly Tektronix instrument configuration, this would
typically mean that the PG509 be installed in a TM 5000
(programmable Plug-In compatible) Power Module, as is
required for the other two devices.
Manual Type:
Service and User Manual
Pages:
49
Size:
2.58 Mbytes (2709986 Bytes)
Language:
english
Revision:
Manual-ID:
070-7755-00
Date:
1989 10 01
Quality:
Scanned document, all readable.
Upload date:
2017 12 28
MD5:
8730b807db3e5022514fae7703d99734
Downloads:
674
Information
ILLUSTRATIONS ...
TABLES ...
OPERATORS SAFETY SUMMARY SERVICING SAFETY SUMMARY .
1 Specification
SPECIFICATION ...
INTRODUCTION ...
PERFORMANCE CONDITIONS
2 System Installation
SYSTEM INSTALLATION ...
PREPARATION FOR USE ...
FRONT PANEL CONTROLS AND CONNECTORS REPACKAGING
INFORMATION ...
3 Applications
APPLICATIONS ...
4 Theory of Operation
THEORY OF OPERATION ...
INTRODUCTION ...
OUTPUT ...
CHARGE LINE ...
POWER SUPPLIES ...
Performance Check Procedures
PERFORMANCE CHECK PROCEDURES ...
INTRODUCTION ...
PERFORMANCE CHECK INTERVAL ...
PREPARATION ...
CHARACTERIZATION OF THE 11801 Oscilloscope
TRANSIENT RESPONSE AND AMPLITUDE VER旧CATION
6 Adjustment Procedures
ADJUSTMENT PROCEDURES ...
INTRODUCTION ...
PERFORMANCE CHECK INTERVAL ...
PREPARATION ...
Power supply VERIFICATION/ADJUSTMENT ...
CHARACTERIZATION OF THE 11801 Oscilloscope ...
TRANSIENTT RESPONSE AND AMPLITUDE VERIFICATION/ADJ
7 Maintenance and Diagnostics
MAIKTTENANCE AND DIAGI GENERAL MAINTENAN
dRCUIT BOARD REMOVAL AND INSTALLATION
SIDE COVERS ...
MAIN BOARD ...
TROUBLESHOOTING ...
8 Options
9 Replaceable Electrical Parts
10 Diagrams 71 Replaceable Mechanical Parts