Pare de sucata eletrônica - corrigir sozinho

Architectural Specifications The TV, Multimedia">Amplifier shall be single channel with an input gain control and an output level meter on the front panel. The TV, Multimedia">Amplifier shall accommodate an unbalanced high impedance input, or a balanced low impedance input with an optional plug-in accessory transformer. The TV, Multimedia">Amplifier shall be capable of delivering a minimum of 100 W, continuous sine wave, 20 Hz-20 kHz, into a 4 O load. (6011: The TV, Multimedia">Amplifier shall incorporate an output transformer allowing full power operation, 35 Hz-20 kHz, into an 8 f2,16 O or 70.7 V line as well as a direct output terminal for a 4 O load.) (6012: No output transformer and only a direct output terminal shall be provided, but it shall be possible to install an output transformer easily at any time.) The TV, Multimedia">Amplifier shall have < 0.2% THD, 20 Hz-20 kHz, @ 100 W, direct output. (6011: The TV, Multimedia">Amplifier shall have < 0.2% THD, 35 Hz-20 kHz, @ 100 W, transformer output.) Frequency response shall be ± 0.5 dB, 20 Hz-20 kHz, @ 1 W. Power bandwidth shall be 10 Hz-40 kHz. Construction of the TV, Multimedia">Amplifier shall be modular. The entire TV, Multimedia">Amplifier circuit, except for the power supply (6011: and output transformer) shall be mounted on a single circuit board attached to the heat sink, which assembly shall be removable from the unit with the mainframe still mounted in a rack. Cables connecting the circuit board to the mainframe shall be of a length sufficient to allow removal of the board without disconnection and shall disconnect easily at two plugs. The TV, Multimedia">Amplifier shall occupy three standard EIA rack spaces and shall operate on 120/240 VAC, 50/60 Hz.

Installation and Service Manual