Apparecchiature informatiche

Collins Telecommunications DL-1 Altro
Collins Telecommunications
Modello: DL-1
Data: 1966
Categoria: Radio Comunicazione
Gruppo: Altro
Descrizione: 100 Watt Resistor Load
                                    The DL-1 is a 100-watt resistor load for use with any
100-watt transmitter or transceiver such as the 32S-1,
32S-3, or KWM-2. Refer to figure 1. Use of this dummy load
allows alignment or adjustment of transmitter circuits
without sustained radiation of an interfering carrier. The
DL-1 consists of four 50-ohm Globar resistors in a
series-parallel arrangement to provide a 50-ohm resistive
load. The DL-1 may be switched locally or remotely to select
antenna or dummy load for connection to transmitter output.
Jacks are provided for 6.3-volt ac 50- to 60-Hz relay coil
supply, remote switching, and transmitter and antenna
connections. The unit can be set on a table or desk or
mounted on any chassis or rack frame by means of the two
tapped holes on the bottom. As an alternate mounting, the
four rubber feet can be removed and the unit mounted on a
flat plate with four 6-32 screws.

Questi manuali sono disponibili per l'attrezzatura di cui sopra:

Tipo manuale: Servizio e manuale utente Collins-9150-Manual-Page-1-Picture
Pagine: 4
Dimensioni: 442.67 Kbytes (453289 Bytes)
Lingua: Inglese
Revisione: Third Printing
Manuale-ID/numero: 523-0106000-101311
Data: 01 gennaio 1966
Qualità: Documento scansionato, la lettura in parte male, non in parte leggibile.
Data di aggiunta:
MD5: d6eca3d7bb677095b036b535aeb7af24
Downloads: 46 dal 04 agosto 2017

Comments (0)

No comments yet. Be the first!

Add Comment

* Required information
Captcha Image
Powered by Commentics