Equipment information
Wavetek 154 Generator
Manufacturer:
Image 1 of 1
If you have any other photos or manuals for the
Wavetek 154 you can upload the files here .
Model:
154
Date:
1980
Category:
Group:
Description:
Programmable waveform generator
Information
The model 154 Programmable Waveform Generator is a precision
source of sine, square and triangle waveforms covering a
frequency range from 0.001 Hz to 10 MHz. In addition, a
calibrated, programmable dc voltage output is provided.
Amplitude, frequency and dc level may be digitally
programmed with three digit resolution. Amplitude, frequency
and dc level may also be modulated by an analog control
voltage. The Generator may be operated in continuous,
triggered or gated modes. All controls may be locally or
remotely programmed. All programming is DTL/TTL compatible.
1.2 PHYSICAL AND ELECTRICAL SPECIFICATIONS
1.2.1 Versatility
Output Signals
DC voltage, Sine , Square and Triangle selectable, with
auxiliary pulse output.
Frequency Range
0.001 Hz to 10 MHz in 10 decade ranges, with 3 digit resolution.
Main Output
DC voltage, ±0.1 Vdc to 10 Vdc at 100 mA maximum. Output
impedance less than 1Ω. ^ , Tj , ,0.001V peak to peak to
10 V peak to peak into 50Ω load. Output impedance 50Ω, All
waveforms may be offset 5 V above or below ground level with
3 digit resolution and selectable polarity. Signal level
plus offset voltage not to exceed ±7.5 V peak into 50Ω load.
Auxiliary Output
50% duty cycle pulse at Generator frequency. Fixed
amplitude, 0 to +6 V peak into open circuit (0 to 3 V into 50Ω).
Operating Modes
Continuous, trigger, or gated mode, selectable. The
Generator may be triggered to produce single cycles by
pushbutton trigger or external trigger command. Any discrete
number of cycles will be produced by applying a gate signal
for the desired burst width when in the gated mode. Minimum
voltage required for trigger = +3 V. 50 V can be applied
without damage.
Analog Modulation Control
The frequency, amplitude and dc offset level of the
Generator can be independently controlled by an external
voltage. The control can be dc programming or wideband
modulation.
Manual Type:
Service and User Manual
Pages:
76
Size:
4.12 Mbytes (4325139 Bytes)
Language:
english
Revision:
revised
Manual-ID:
Date:
Quality:
Scanned document, all readable.
Upload date:
2014 11 09
MD5:
2f7b3d96ccf79496e991e9f4ddc30c5b
Downloads:
685
Information
This manual provides descriptive material and instructions
for the installation, operation, maintenance, and repair of
this instrument. Wavetek's product improvement program
ensures that the latest electronic developments are
incorporated in all Wavetek instruments by the addition of
circuit and component changes as rapidly as development and
testing permit. Due to the time required to document and
print instruction manuals, it is not always possible to
incorporate the more recent changes in the released manual.
In this case, data will be found on engineering change
sheets at the rear of the manual. If no change sheets are
included, the manual is correct as printed.
iv
Manual Type:
Service and User Manual
Pages:
76
Size:
4.14 Mbytes (4342999 Bytes)
Language:
english
Revision:
Revised
Manual-ID:
Date:
Quality:
Scanned document, reading partly badly, partly not readable.
Upload date:
2011 11 06
MD5:
660f7722c023f0f35e89c9be2a35d181
Downloads:
657