Información sobre equipo

Wavetek 184 Generador
Fabricante:
Wavetek
Modelo: 184
Fecha: 1980
Categoría: Los instrumentos de medición
Grupo: Generador
Descripción: 5MHz Sweep Generator
Información:

THE MODEL 184 Wavetek model 184, the 5 MHz Sweep Generator, is a precision source of sine, triangle, square, positive pulse and negative pulse waveforms plus dc voltage. Frequency of the waveforms is manually and remotely variable from 100µHz to 5 MHz. The Generator can repetitively sweep between two individually set frequencies and at a particular sweep rate. The amplitude of waveforms is variable from 20V p-p, open circuit maximum, to —80 dB. DC reference of the waveforms can be offset positively and negatively. The symmetry of the waveforms is continuously adjustable from approximately 1:19 to 19:1. Varying symmetry provides variable duty cycle pulses, sawtooth and asymmetrical sine waveforms. A voltage representing Generator frequency, a fixed-amplitude pulse train of that frequency, and a voltage ramp representing frequency sweep rate are provided as front panel outputs.

Estos manuales están disponibles para el equipo anterior:

Tipo de Manual:: Servicio y Manual del usuario Wavetek-11106-Manual-Page-1-Picture
Páginas:: 52
Tamaño:: 1.59 Mbytes (1672042 Bytes)
Idioma: Inglés
Revisión:
Número de identificación:
Fecha: 01 febrero 1980
Calidad: Documento Scaneds, en parte leyendo mal, no parcialmente legible.
Añadir fecha:
MD5: 0bc85881272d20be9947e91dcbc07846
Descargas: 37 desde 13 agosto 2018
Información:

1.1 THE model 184 ... 1-1 1.2 SPECIFICATIONS ... 1-1 SECTION 2 INITIAL PREPARATION 2.1 UNPACKING INSPECTION ... 2-1 2.2 PREPARATION FOR USE ... 2-1 2.3 ELECTRICAL ACCEPTANCE CHECK ... 2-1 SECTION 3 OPERATION 3.1 CONTROLS AND CONNECTORS ... 3-1 3.2 OPERATION ... 3-4 3.2.1 Signal Termination . ... 3-4 3.2.2 Continuous Operation ... . 3-5 3.2.3 Trigger Mode ... 3-5 3.2.4 Triggering ... 3-6 3.2.5 GATED (or Tone Burst) Mode ... 3-6 3.2.6 SWEEP Mode ... 3-6 3.2.7 Voltage Control - VCG ... 3-6 SECTION 4 CIRCUIT DESCRIPTION 4.1 VOLTAGE CONTROL LED GEN ERATO ft ... 4-1 4.2 SWEEP Generator ... 4-2 SECTION 5 CALIBRATION 5.1 FACTORY REPAIR ... 5-1 5.2 REQUIRED TEST EQUIPMENT ... 5-1 5.3 REMOVING Generator COVER ... 5-1 5.4 CALIBRATION ... 5-1 SECTION 6 TROUBLESHOOTING 6.1 INTRODUCTION ... 6-1 6.2 CIRCUIT BOARD ACCESS ... 6-1 6.3 BASIC TECHNIQUES ... 6-1 6.4 TROUBLESHOOTING INDIVIDUAL COMPONENTS ... 6-1 6.5 TROUBLESHOOTING GUIDE ... 6-2 SECTION 7 PARTS AND SCHEMATICS 7.1 DRAWINGS ... 7-1 7.2 ORDERING PARTS ... 7-1 7.3 ADDENDA ... 7-1

Wavetek-11106-Manual-Page-1-Picture


Comments (0)

No comments yet. Be the first!

Add Comment

* Required information
1000
Captcha Image
Powered by Commentics