Información sobre equipo

Tektronix 7D14 Contador
Fabricante:
Tektronix
Modelo: 7D14
Fecha: 1971
Categoría: Los instrumentos de medición
Grupo: Contador
Descripción: Digital Counter plug in unit
Información:
                                    Introduction

The 7D14 Digital Counter plug in unit is designed for use
with Tektronix 7000-series Oscilloscopes equipped with
readout system. The 7D14 uses the readout system to display
an eight-digit readout on the CRT of the associated
oscilloscope. The 7D14 will measure frequency from 0 to 525
megahertz, frequency ratio from 0 to 10s: 1 and totalize
(count number of events) from 0 to 108. The 7D14 features
counting capability to 525 megaherjz without prescaling,
input impedance of 50 ohms or 1 megohm, blanking of all
zeros to the left of the most significant digit.
trigger pickoff from vertical amplifier unit (which allows
simultaneous signal viewing and counting, and a trigger
indicator analog CRT display to view the “shaped'' input signal.

Estos manuales están disponibles para el equipo anterior:

Tipo de Manual:: Servicio y Manual del usuario Tektronix-8955-Manual-Page-1-Picture
Páginas:: 116
Tamaño:: 23.29 Mbytes (24421482 Bytes)
Idioma: Inglés
Revisión:
Número de identificación: 070-1097-00
Fecha: 01 marzo 1971
Calidad: Documento Scaned, todo legible.
Añadir fecha:
MD5: 4aa97cf32716d10fd7ff9a5a92d560a8
Descargas: 75 desde 23 abril 2017
Información:
SECTION 1 SPECIFICATION	Page

Introduction	1-1

Electrical Characteristics	1-1

Environmental Characteristics	1-5

Physical Characteristics	1-5

SECTION 2 OPERATING INSTRUCTIONS

Installation	2-1

Display	2-1

Controls and Connectors	2-1

First-Time Operation	2-4

General Operating Information	2-5

Measurement Modes	2-8

Operating Modes	2-10

SECTION 3 CIRCUIT DESCRIPTION

Introduction	3-1

Block Diagram Description	3-1

Detailed Circuit Description	3-3

SECTION 4 MAINTENANCE

Introduction	4-1

Preventive Maintenance	4-1

Troubleshooting	4-1

Replacement Parts	4-4

Component Replacement	4-4

SECTION 5 CALIBRATION

Recalibration Interval	5-1

Test Equipment Required	5-1

Part I — Performance Check	5-4

Part II — Adjustment	5-12
SECTION 6 ELECTRICAL PARTS LIST

Abbreviations and Symbols Parts Ordering Information

SECTION 7 DIAGRAMS AND CIRCUIT BOARD ILLUSTRATIONS

Symbols and Reference Designators Voltage and Waveform
Conditions

SECTION 8 MECHANICAL PARTS LIST

Mechanical Parts List Information Index of Mechanical Parts
Illustrations Mechanical Parts List Accessories
Tektronix-8955-Manual-Page-1-Picture


Comments (0)

No comments yet. Be the first!

Add Comment

* Required information
1000
Captcha Image
Powered by Commentics