Información sobre el equipo

Electronic Navigation Industries 300L Amplificador
Fabricante:
Modelo:
300L
Fecha:
1969
Categoría:
Grupo:
Descripción:
BroadBand RF Power Amplifier

Información

The Model 300L is a broadband solid state power amplifier, covering the frequency range of 250 KHz to 110 MHz. Three watts of RF power can be produced at the output, with low harmonic and intermodulation distortion. The Amplifier will accept inputs of AM, FM, SSB, Pulse and other complex modulations, over its entire frequency range. The 40 dB gain of the unit permits it to be driven to its full power output by any signal or sweep generator capable of supplying a minimum -5 dBM (.13 volts) signal level into its 50 ohm input. Virtually all commercial signal and sweep generators are capable of supplying this signal. The Model 300L operates over its entire bandwidth without tuning or other adjustments. It is capable of supplying useful power output up to 150 MHz, at reduced gain. It is unconditionally stable and will not oscillate for any possible combination of source and load impedances. This feature is especially useful where highly reactive loads are encountered. Reflected power due to output load mismatch is absorbed in the Amplifier. The Model 300L is protected against failure due to output load mismatch and/or overdrive. The unit will withstand a +20 dB overdrive (input signal of +15 dBM), for all output load conditions including both short and open circuit loads.

Ver más

Servicio y Manual del usuario
Tipo de Manual
Servicio y Manual del usuario
Páginas:
21
Tamaño:
549.06 Kbytes (562235 Bytes)
Idioma:
english
Revisión:
Manuel-ID:
Fecha:
Calidad:
Documento Scaned, todo legible.
Fecha de subida:
25 enero 2016
MD5:
14b1db7f544c1e7114a769b57666b1f6
Descargas:
398

Información

CHAPTER 1 - GENERAL INFORMATION 1.1 INTRODUCTION 1.2 SPECIFICATIONS 1.3 INSTRUMENT IDENTIFICATION CHAPTER 2 - OPERATION 2.1 INTRODUCTION 2.2 MAINS VOLTAGE SETTING 2.3 MAINS FUSE RATING 2.4 RACK INSTALLATION 2.5 OPERATION CHAPTER 3 - PRINCIPLES OF OPERATION 3.1 BLOCK DIAGRAM DESCRIPTION CHAPTER 4 - MAINTENANCE AND PERFORMANCE TESTS 4.1 INITIAL CHECK 4.2 GAIN AND GAIN VS FREQUENCY 4.3 CALIBRATION 4.4 RF POWER OUTPUT 4.5 MEASUREMENT OF HARMONICS 4.6 TROUBLESHOOTING AND REPAIR 4.7 MAINTENANCE 4.8 PRECAUTIONS CHAPTER 5 - SCHEMATICS AND PARTS LIST 5.1 POWER DISTRIBUTION SCHEMATIC 5.2 RF AMPLIFIER SCHEMATIC 5.3 PARTS LIST 5^4 GLOSSARY OF ABBREVIATIONS 5,5 LIST OF MANUFACTURERS

Ver más

Agregar comentario

* Información requerida
1000
Captcha Imagen

Comentarios

Sin comentarios aún. ¡Sé el primero!