Información sobre el equipo

Wavetek 1004-1 Generador
Fabricante:
Modelo:
1004-1
Fecha:
1977
Categoría:
Grupo:
Descripción:
SWEEP/SIGNAL GENERATOR

Información

The Wavetek 1000 Series Sweep/Signal generators are single band instruments covering the frequency range from 500 KHz to 1.4 GHz. All units utilize the same, Front Panel, Harness and Power supply with the balance of the circuits contained in Plug-In Modules. However, it is not intended that one model be converted to another. The Plug-In concept simplifies maintenance problems and provides marker circuits which can be customized to specific applications. A Rear Panel Con nector permits remote programming of Center Frequency, Sweep Width and Output Level, plus. External Amplitude and Frequency Modulation.

Ver más

Servicio y Manual del usuario
Tipo de Manual
Servicio y Manual del usuario
Páginas:
77
Tamaño:
5.97 Mbytes (6263685 Bytes)
Idioma:
english
Revisión:
revised
Manuel-ID:
Fecha:
Calidad:
Documento Scaned, todo legible.
Fecha de subida:
09 noviembre 2014
MD5:
bb6322721f7d6c0b5456cad22d34d599
Descargas:
2814

Información

This manual provides descriptive material and instructions for the installation, operation, maintenance, and repair of the Wavetek Model 1001A to 1005 Sweep/Signal Generator. SECTION 1 -GENERAL INFORMATION 1.1 INTRODUCTION 1.2 SPECIFICATIONS 1.3 OPTIONS 1.4 ACCESSORIES SECTION 2-INSTALLATION 2.1 MECHANICAL INSTALLATION 2.2 ELECTRICAL INSTALLATION SECTION 2—OPERA TING INSTRUCTIONS 31 INTRODUCTION 3.2 DESCRIPTION OF FRONT PANEL 3.3 DESCRIPTION OF REAR PANEL 3.4 TYPICAL OPERATING SET UP 3.5 SPECIAL OPERATING NOTES 3.6 PROGRAMMING SECTION 4 - CIRCUIT DESCRIPTION 4.1 INTRODUCTION 4.2 SIMPLIFIED BLOCK DIAGRAM 4.3 POWER SUPPLY 4 4 SWEEP RATE (MODULE M1H) 4.5 SWEEP DRIVE (MODULE M2G) 4.6 SWEEP OSCILLATOR FOR MODEL 1001A and 1002 (MODULE M9G and M9H) 4 7 OUTPUT AMPLIFIER FOR MODEL 1001A and 1002 (MODULE M1 OF and M10G) 4.8 SWEEP OSCILLATOR FOR MODEL 1003 1004. and 1005 (MODULE M9R S and'T) 49 MARKER ADDER (MODULE M5G) 4.10 MARKERS (MODULE M6s) SECTION 5 MAINTENANCE 5.1 INTRODUCTION 5.2 SERVICE INFORMATION 5.3 PERFORMANCE CHECKS 5.4 CALIBRATION PROCEDURE 5.5 TROUBLESHOOTING SECTION 6 -SCHEMATICS & PARTS LIST 6.1 INTRODUCTION 6.2 MANUFACTURERS CODE 6.3 SCHEMATIC NOTES 6.4 ABBREVIATION CODE SCHEMATICS AND PARTS LIST

Ver más

Agregar comentario

* Información requerida
1000
Captcha Imagen

Comentarios

Sin comentarios aún. ¡Sé el primero!