Equipment information

Icom IC-M501EURO Transceiver
Manufacturer:
Icom
Model: IC-M501EURO
Date: 2000
Category: Radio, Communication
Group: Transceiver
Description: VHF MARINE TRANSCEIVER
Information:

‘ GENERAL • Frequency coverage : 156.025–157.425 MHz (Tx) 156.025–162.025 MHz (Rx) • Mode : 16K0G3E (FM) • Usable channels : All international and USA* channels *availability depending on version • Power Supply requirement : 13.8 V DC (negative ground) • Usable temperature range : –20°C to +60°C • Frequency stability : ±10 ppm (–20°C to +60°C) • Current drain (at 13.8 V DC) : Transmit at 25 W 6.0 A Receive max. audio 1.2 A • Antenna connector : SO-239 (50 Ω) • Dimensions (projections not included) : 165(W)×110(H)×109.4(D) mm • Weight : 1130 g ‘ Transmitter • Output power (at 13.8 V DC) : High 25 W Low 1 W • Modulation : Variable reactance frequency modulation • Maximum frequency deviation : ±5.0 kHz • Spurious emissions : 0.25 μW • Adjacent channel power : 70 dB • Residual modulation : 40 dB • Audio harmonic distortion : Less than 10% at 60% deviation • Audio frequency response : +1 dB to –3 dB of 6 dB octave from 300 Hz to 3000 Hz • Microphone impedance : 600 Ω ‘ Receiver • Receive system : Double conversion superheterodyne system • Intermediate frequencies : 1st 21.7 MHz 2nd 450 kHz • Sensitivity : 6 dBμ emf at 20 dB SINAD • Squelch sensitivity : –10 dBμ at threshhold • Adjacent channel selectivity : 70 dB • Spurious response : 70 dB • Intermodulation rejection ratio : 68 dB • Hum and noise : 40 dB • Audio output power (at 13.8 V DC) : 3.5 W typical at 10% distortion with an 4 Ω load • Audio frequency responce : +1 dB to –3 dB of –6 dB octave from 300 Hz to 3000 Hz

These manuals are available for the above equipment:

Manual Type: Service Manual Icom-2258-Manual-Page-1-Picture
Pages: 40
Size: 4.23 Mbytes (4432303 Bytes)
Language: english
Revision:
Manual-ID/Number: S-13702HZ-CD
Date: 2000
Quality: Electronic document, no scan, very well readable.
Upload date:
MD5: a6417de98e68697726945cf4b2eb6581
Downloads: 430 since 14 January 2011
Information:

TABLE OF CONTENTS SECTION 1 SPECIFICATIONS SECTION 2 INSIDE VIEWS SECTION 3 OPTIONONAL UNIT INSTALLATION SECTION 4 CIRCUIT DESCRIPTION 4 - 1 Receiver CIRCUITS ... 4 - 1 4 - 2 Transmitter CIRCUITS ... 4 - 2 4 - 3 PLL CIRCUIT ... 4 - 3 4 - 4 DSC CIRCUIT ... 4 - 3 4 - 5 Power Supply CIRCUITS ... 4 - 4 4 - 6 LOGIC CIRCUITS ... 4 - 4 SECTION 5 ADJUSTMENT PROCEDURES 5 - 1 PREPARATION ... 5 - 1 5 - 2 PLL ADJUSTMENTS ... 5 - 2 5 - 3 Transmitter ADJUSTMENTS ... 5 - 2 5 - 4 Receiver ADJUSTMENTS ... 5 - 4 SECTION 6 PARTS LIST SECTION 7 MECHANICAL PARTS 7 - 1 IC-M501EURO ... 7 - 1 7 - 2 HM-126 ... 7 - 1 SECTION 8 SEMI-CONDUCTOR INFORMATION SECTION 9 BOARD LAYOUTS 9 - 1 LOGIC UNIT ... 9 - 1 9 - 2 MAIN UNIT ... 9 - 3 9 - 3 DSC UNIT ... 9 - 5 9 - 4 ANT UNIT ... 9 - 5 9 - 5 PWR-CORD UNIT ... 9 - 5 9 - 6 VR UNIT ... 9 - 5 9 - 7 SQL UNIT ... 9 - 5 9 - 8 DIAL UNIT ... 9 - 5 9 - 9 HM-126 ... 9 - 6 SECTION 10 BLOCK DIAGRAM SECTION 11 VOLTAGE DIAGRAM 11 - 1 LOGIC UNIT ... 11 - 1 11 - 2 MAIN UNIT ... 11 - 2

Icom-2258-Manual-Page-1-Picture


Comments (0)

No comments yet. Be the first!

Add Comment

* Required information
1000
Captcha Image
Powered by Commentics