|Tektronix SG 504 Generator|
|Description:||Leveled Sine-Wave Generator|
The SG 504 provides a constant-amplitude sine wave over a frequency range from 245 MHz to 1050 MHz. Amplitude-reference sine waves of .05 MHz or 6.0 MHz (selected by internal switch) are provided. The output head has an output impedance of 50 ohms. The peak-to-peak voltage from the output head is adjusted by a calibrated five-turn potentiometer. The SG 504 Leveled Sine Wave Generator is designed for use in the TM 500 series power modules. The front-panel FREQUENCY MONITOR OUT connector provides at least a 0.3 V peak-to-peak signal at the selected output frequency (245 to 1050 MHz) for monitoring or external triggering. There is also a provision for frequency modulating the 245 to 1050 MHz output signal. When lit, the UNLEVELED light indicates a mismatched load or when the OUTPUT AMPLITUDE front-panel control should be turned counterclockwise. When the output head is disconnected from the front panel, the UNLEVELED light is also illuminated. Rear Interface connections are provided for the FM INPUT, FREQUENCY MONITOR OUT, and amplitude control. If the rear Interface is used, these front panel features must be disconnected. They cannot both be used at once.
These manuals are available for the above equipment:
|Tektronix -- SG 504 -- Service and User Manual|
|Manual Type:||Service and User Manual|
|Size:||18.18 Mbytes (19063155 Bytes)|
|Date:||01 August 1981|
|Quality:||Scanned document, all readable.|
|Upload date:||27 December 2017|
|Downloads:||140 since 27 December 2017|
SECTION 1 OPERATING INSTRUCTIONS 1-1 French Version German Version Japanese Version SECTION 2 SPECIFICATION AND PERFORMANCE CHECK 2-1 WARNING I The remaining portion of this Table of Contents lists servicing instructions that expose personnel to hazardous voltages. These instructions are for qualified service personnel only. SECTION 3 ADJUSTMENT 3-1 SECTION 4 MAINTENANCE AND INTERFACING INFORMATION 4-1 SECTION 5 CIRCUIT DESCRIPTION 5-1 SECTION 6 OPTIONS 6-1 SECTION 7 REPLACEABLE ELECTRICAL PARTS 7-1 SECTION 8 DIAGRAMS AND CIRCUIT BOARD ILLUSTRATION 8-1 SECTION 9 REPLACEABLE MECHANICAL PARTS AND EXPLODED VIEW 9-1 CHANGE INFORMATION
|Start Free Download|
These terms and conditions contain rules about posting comments. By submitting a comment, you are declaring that you agree with these rules:
- Although the administrator will attempt to moderate comments, it is impossible for every comment to have been moderated at any given time.
- You acknowledge that all comments express the views and opinions of the original author and not those of the administrator.
- You agree not to post any material which is knowingly false, obscene, hateful, threatening, harassing or invasive of a person's privacy.
- The administrator has the right to edit, move or remove any comment for any reason and without notice.
Failure to comply with these rules may result in being banned from further commenting.
These terms and conditions are subject to change at any time and without notice.