Equipment information

Collins Telecommunications DL-1 Other
Manufacturer:
Collins Telecommunications
Model: DL-1
Date: 1966
Category: Radio, Communication
Group: Other
Description: 100 Watt Resistor Load
Information:

The DL-1 is a 100-watt resistor load for use with any 100-watt Transmitter or Transceiver such as the 32S-1, 32S-3, or KWM-2. Refer to figure 1. Use of this dummy load allows alignment or adjustment of Transmitter circuits without sustained radiation of an interfering carrier. The DL-1 consists of four 50-ohm Globar resistors in a series-parallel arrangement to provide a 50-ohm resistive load. The DL-1 may be switched locally or remotely to select Antenna or dummy load for connection to Transmitter output. Jacks are provided for 6.3-volt ac 50- to 60-Hz relay coil supply, remote switching, and Transmitter and Antenna connections. The unit can be set on a table or desk or mounted on any chassis or rack frame by means of the two tapped holes on the bottom. As an alternate mounting, the four rubber feet can be removed and the unit mounted on a flat plate with four 6-32 screws.

These manuals are available for the above equipment:

Manual Type: Service and User Manual Collins-9150-Manual-Page-1-Picture
Pages: 4
Size: 442.67 Kbytes (453289 Bytes)
Language: english
Revision: Third Printing
Manual-ID/Number: 523-0106000-101311
Date: 01 January 1966
Quality: Scanned document, reading partly badly, partly not readable.
Upload date:
MD5: d6eca3d7bb677095b036b535aeb7af24
Downloads: 56 since 04 August 2017
Information:

Collins-9150-Manual-Page-1-Picture


Comments (0)

No comments yet. Be the first!

Add Comment

* Required information
1000
Captcha Image
Powered by Commentics