Equipment information

Cornell Dubilier Electronics AR-33 Antenna
Manufacturer:
Cornell Dubilier Electronics
Model: AR-33
Date: 1976
Category: Radio, Communication
Group: Antenna
Description: Autorotor
Information:

The Cornell-Dubilier Model AR-33 Autorotor Rotor is designed to support and rotate the largest television antennae. The AR-33 is not intended for large Ham beams. For extremely windy areas or large beams, the CDE Ham-M rotor is recommended.. The AR-33 is rated to support a dead vertical weight of 150 pounds, has 500 inch pounds of motor stall torque, and resists an overturning moment of approximately 4000 inch pounds without guying. Rotation is controlled within two degrees accuracy. The rotor is lubricated for long fife and will operate suitably at minus 20 degrees Fahrenheit. The unit is shipped from the factory set at the end of rotation in full "North" counter-clockwise position (looking down at top of rotor). Note that the rotor mast clamps are reversible thus allowing clamping to large diameter (up to 2") or small diameter (down to 7/8") masts. The lower mast support, which is shipped unmounted, is not used when the rotor is mounted in a tower. Standard five-wire rotor control cable is available from any electronics supply house. The following wire sizes are recommended:

These manuals are available for the above equipment:

Manual Type: Service and User Manual CDE-9123-Manual-Page-1-Picture
Pages: 8
Size: 2.63 Mbytes (2755883 Bytes)
Language: english
Revision: H
Manual-ID/Number: ADO 50579-00
Date: 01 January 1976
Quality: Scanned document, reading partly badly, partly not readable.
Upload date:
MD5: de588066ab8c8f02aa5b2dda8778946a
Downloads: 93 since 01 August 2017
Information:

CDE-9123-Manual-Page-1-Picture


Comments (0)

No comments yet. Be the first!

Add Comment

* Required information
1000
Captcha Image
Powered by Commentics