Geräte Informationen

Hewlett Packard 8656A Generator
Hersteller:
Modell:
8656A
Datum:
1981
Kategorie:
Gruppe:
Beschreibung:
Signal Generator

Informationen

The Hewlett-Packard Model 8656A is a synthesized signal Generator with a carrier frequency range of 100 kHz to 990 MHz. Its output amplitude is leveled and calibrated from +13 to -127 dBm. AM and/or FM functions can be individually selected. The carrier frequency, output amplitude, and modulation functions can be remotely programmed via the Hewlett-Packard Interface Bus. The unique modular design and incorporated service features permit rapid and easy calibration and service.

mehr

Service- und Bedienungsanleitung
Dokumenttyp:
Service- und Bedienungsanleitung
Seitenanzahl:
557
Dateigröße:
41.40 Mbytes (43413053 Bytes)
Sprache:
english
Revision:
Dokument-ID:
08656-90107
Datum:
Qualität:
Gescanntes Dokument, teilweise schwer oder teilweise nicht zu lesen.
Upload Datum:
24 November 2013
MD5:
dd491d95b8ca282105f87f6ea63cf08d
Downloads:
775

Informationen

This manual applies directly to instruments with serial numbers prefixed 2035A. With changes described in Section VII, this manual also applies to instruments with serial numbers prefixed 2032A, 2027A, 2026A, 2025A, 2024A, 2023A, 2022A, 2018A, 2014A, and 2009A. For additional important information about serial numbers, see INSTRUMENTS COVERED BY MANUAL in Section I. This section of the manual describes the instruments documented by this manual and covers instrument description, options, accessories, specifications, and other basic information. The other sections contain the following information: Section II, Installation: provides information about initial inspection, preparation for use (including time base selection and HP-IB address selection for remote operation), and storage and shipment. Section III, Operation: provides information about panel features and includes operator’s checks, operating instructions for both local and remote operation, and operator’s maintenance information. Section IV, Performance Tests: provides the information required to check performance of the instrument against the critical specifications listed in Table 1-1. Section V, Adjustments: provides the information required to properly adjust the instrument. Section VI, Replaceable Parts: provides ordering information for all replaceable parts and assemblies. Section VII, Manual Changes: with the backdating information, this manual applies to all instruments as indicated on the title page. Section VIII, Service: provides the information required to repair the instrument.

mehr

Kommentar hinzufügen

* Pflichtfeld
1000
Captcha Image

Kommentare

Noch keine Kommentare, sei der erste Poster!