Equipment information

Farnell Instruments GORSQ E SERIES Power supply
Manufacturer:
Model:
GORSQ E SERIES
Date:
1991
Category:
Group:
Description:
bench Power Supply

Information

This book covers all models in the E/B series of stabilised bench power supplies. The series offer a choice of output voltage and output current. By use of a slider switch the precision analogue meter is used to display output voltage or output current. A push button switch is used to turn the Power supply on and off. A green LED is used to indicate the power ‘on’ condition. A 10 turn precision potentiometer is use to vary the output voltage over its range from near zero to its maximum rating. The Power supply is protected against current overloads by electronic current limiting preset at approximately 110% of the nominal output current rating. In operation this circuit remains approximately constant. On removal of the overload the output will reset to its original value. The current limit condition is indicated by a red LED near the output terminals. The Power supply incorporates circuitry that gives limited protection against the application of external voltages in the reverse and forward mode and thus the unit may be used for battery charging and parallel applications.

show more

Service Manual
Manual Type:
Service Manual
Pages:
32
Size:
9.34 Mbytes (9790622 Bytes)
Language:
english
Revision:
Manual-ID:
9HEB
Date:
Quality:
Scanned document, all readable.
Upload date:
2016 01 25
MD5:
c5181e17b6b7457e573b09278d01b02c
Downloads:
689

Information

1. SCHEDULE OF EQUIPMENT ... 2 2. INTRODUCTION ... 3 3. SPECIFICATION ... 4 4. INSTALLATION ... 6 5. OPERATING INSTRUCTIONS ... 7 6. APPLICATIONS ... 8 7. CIRCUIT DESCRIPTION ... 9 8. RECALIBRATION ... 10 9. MAINTENANCE ... 11 10. CIRCUIT DIAGRAMS ... 12

show more