Equipment information

Cushman Electronics Inc. CE-7 Communications Service Monitor
Manufacturer:
Model:
CE-7
Date:
Category:
Group:
Description:
Multi-Channel FM Communications Monitor

Information

The Model CE-7 Multi-Channel FM Communications Monitor is designed to measure the frequency and frequency-modulation deviation of transmitters and other signal sources. The CE-7 is crystal controlled and can operate on any one of 23 frequencies between 20 MHz and 1150 MHz. Which frequencies are assigned to the 23 positions is specified by the customer. Any number of crystals between one and 23 may be selected and the operation of the instrument is not compromised if only one or two crystals are installed. The Cushman Model MCO-6 Multi-Channel Oscillator (accessory) offers an additional 23 frequencies should the need for other crystal frequencies arise. The CE-7 can also generate FM and CW signals within the frequency limits stated above. The output level of the generated signal may be adjusted from 0. 1 to 100 microvolts and provides the capability of determining the sensitivity of FM communication receivers. Signal generation of up to ten optional crystal-controlled IF frequencies is available between 250 kHz and 13. 5 MHz. The output levels of the IF signals are continuously variable. The CE-7 must operate with either a Model 301 Oscilloscope or a Model 302 FM Deviation Meter inserted into the left-hand plug-in cavity, and a Model 303 Broadband Mixer or one of the RF plug-ins inserted into the right-hand plug-in cavity. The combination of the plug-ins is at the discretion of the customer.

show more

Service and User Manual
Manual Type:
Service and User Manual
Pages:
96
Size:
16.29 Mbytes (17078732 Bytes)
Language:
english
Revision:
Manual-ID:
Date:
Quality:
Scanned document, reading partly badly, partly not readable.
Upload date:
2017 08 07
MD5:
13f5ff5f0449bc9b57dcbfab9b1b31ac
Downloads:
774

Information

WARRANTY ... üi SECTION 1 GENERAL DESCRIPTION ... 1-1 1.1 Introduction ... 1-1 1.2 Accessories ... 1-2 1. 2.1 Plug-In Units ... 1-2 1.2.2 External Instruments ... 1-3 1.2.3 Auxiliary Items ... 1-3 1.3 Specifications ... 1-3 SECTION 2 INSTALLATION ... 2-1 2.1 Unpacking and Inspection ... 2-1 2.2 Environmental ... 2-1 2.2.1 Temperature ... 2-1 2.2.2 RF Fields ... 2-1 2.3 Power Requirements ... 2-1 2.4 Warm-up Requirements ... 2-1 2.5 Preparation for Reshipment ... 2-1 SECTION 3 OPERATING INSTRUCTIONS ... 3-1 3.1 Introduction ... 3-1 3.2 Controls and Indicators ... 3-1 3.3 Starting Procedure ... 3-1 3.4 Operating Procedures ... 3-5 3.4.1 Frequency and Deviation Measurement ... 3-5 3.4.2 CW-Signal Generation ... 3-6 3.4.3 FM-Signal Generation ... 3-6 3.4.4 IF-Signal Generation ... 3-7 3.4.5 Installation and Removal of IF-Oscillators ... 3-7 3.4.6 Antenna Installation ... 3-8 3.4.7 Installation and Removal of Crystals ... 3-8 3.5 Turn-Off Procedure ... 3-8 SECTION 4 CIRCUIT DESCRIPTION ... 4-1 4.1 Introduction ... 4-1 4.2 Second IF and Discriminator Board ... 4-2 4.3 Power-Supply Board ... 4-7 4.4 Frequency Error Meter Board ... 4-8 4. 5 Harmonic Generator Board ... 4-8 4.6 Multi-Oscillator Board ... 4-10 4.7 IF Oscillator Board ... 4-12 4. 8 Signal-Generator Mixer ... 4-12 SECTION 5 MAINTENANCE ... 5-1 5.1 Introduction ... 5-1 5.2 Access ... 5-1 5.3 Fuses ... 5-1 5. 4 Adjustment Procedures and Check ... 5-1 5.4.1 Power-Supply Board, Voltage Adjustment ... 5-2 5.4.2 Crystal-Oscillator Adjustment ... 5-2 5.4.3 Frequency-Meter Adjustment ... 5-3 5.4.4 20-dB Fixed-Attenuator Loss Check ... 5-10 5. 4. 5 Signal-Generation-Output Level Adjustment ... 5-11 5.4.6 Signal-Generator-Mixer Input Level Check ... 5-11 5.5 Troubleshooting Procedures ... 5-13 SECTION 6 SCHEMATICS, PARTS LISTS, AND PARTS PICTORIALS ... 6-1 6.1 Introduction ... 6-1 6.2 Schematics, Parts Lists, Parts Pictorials ... 6-3 6.2.1 Second IF and Discriminator Board ... 6-3 6.2.2 Power Supply Board ... 6-7 6.2.3 Frequency Error Meter Board ... 6-11 6.2.4 Harmonic Generator Board ... 6-13 6.2.5 Multi-Oscillator Board ... 6-17 6.2.6 IF Oscillator Board ... 6-21 6.2.7 IF Oscillator Board ... 6-23 6.2.8 Signal Generator Mixer ... 6-25 6.2.9 Crystal Oven Assembly ... 6-27 6.2.10 Main Chassis ... 6-31 6.2.11 Front Panel ... 6-35 6.2.12 Rear Panel ... 6-39 6.2.13 Covers and Carrying Cases ... 6-41 CUSTOMER-COMMENT CARDS

show more