Equipment information
Farnell Instruments GORSQ E SERIES Power supply
Manufacturer:
No picture available!
Maybe you can upload a pic for the
Farnell Instruments GORSQ E SERIES ?
If you have any other manuals for the
Farnell Instruments GORSQ E SERIES you can upload the files here .
Model:
GORSQ E SERIES
Date:
1991
Category:
Group:
Description:
bench Power Supply
Information
This book covers all models in the E/B series of stabilised
bench power supplies. The series offer a choice of output
voltage and output current.
By use of a slider switch the precision analogue meter is
used to display output voltage or output current. A push
button switch is used to turn the Power supply on and off. A
green LED is used to indicate the power ‘on’ condition. A 10
turn precision potentiometer is use to vary the output
voltage over its range from near zero to its maximum rating.
The Power supply is protected against current overloads by
electronic current limiting preset at approximately 110% of
the nominal output current rating. In operation this circuit
remains approximately constant. On removal of the overload
the output will reset to its original value.
The current limit condition is indicated by a red LED near
the output terminals.
The Power supply incorporates circuitry that gives limited
protection against the application of external voltages in
the reverse and forward mode and thus the unit may be used
for battery charging and parallel applications.
Manual Type:
Service Manual
Pages:
32
Size:
9.34 Mbytes (9790622 Bytes)
Language:
english
Revision:
Manual-ID:
9HEB
Date:
Quality:
Scanned document, all readable.
Upload date:
2016 01 25
MD5:
c5181e17b6b7457e573b09278d01b02c
Downloads:
689
Information
1. SCHEDULE OF
EQUIPMENT ... 2
2.
INTRODUCTION ... 3
3.
SPECIFICATION ... 4
4.
INSTALLATION ... 6
5. OPERATING
INSTRUCTIONS ... 7
6.
APPLICATIONS ... 8
7. CIRCUIT
DESCRIPTION ... 9
8.
RECALIBRATION ... 10
9.
MAINTENANCE ... 11
10. CIRCUIT
DIAGRAMS ... 12