Apparatuur informatie
AIE Automated Industrial Electronics 920 Level Meter | ||
---|---|---|
Fabrikant: |
AIE Automated Industrial Electronics |
|
Model: | 920 | |
Datum: | ||
Categorie: | Meetinstrumenten | |
Groep: | Level Meter | |
Beschrijving: | STANDARD DEVIATION METER | |
Informatie: | ||
Deze handboeken zijn beschikbaar voor de bovengenoemde apparatuur:
AIE Automated Industrial Electronics -- 920 -- Service-en gebruikershandleiding | ||
---|---|---|
Manueel de Type: | Service-en gebruikershandleiding | ![]() |
Pagina 's: | 31 | |
Grootte: | 2.85 Mbytes (2983841 Bytes) | |
Taal: | Engels | |
Herziening: | ||
Handleiding-ID/Number: | ||
Datum: | ||
Kwaliteit: | Gescand document alle leesbaar. | |
Uploaden datum: | 16 maart 2013 | |
MD5: | 364040f407542b367997a43ffb4ffab2 | |
Downloads: | 227 Sinds 16 maart 2013 | |
Informatie: | ||
Foreword
Front View of Model 92 0
Block Diagram
TABLE OF CONTENTS
PAGE
Section I INTRODUCTION
A. Scope of manual
Section I1 DESCRIPTION AND DATA
A. General
B. Technical Characteristics
C. DesignFeatures
D. Components Supplied
E. Packaging
Section 111 CONTROL FUNCTIONS
A. Power
B. Input Gain Control
C. Local Oscillator Tuning
D. FineTuning
E. Meter Range Switch
F. Audio Spkr
G. Audio Level
H. Scope
I. + Deviation -
Section IV POWER SUPPLY
A. Battery Operation
B. A. C. Operation
C. Battery Recharging Procedure
Section V OPERATION
A. Deviation Measurements
B. Distortion Measurements
C. Noise Measurements
Section VI MAINTENANCE
A. General Precautions
B. Battery Installation
C. Removing the Instrument from the Case
D. Distortion Adjust
E. Filter Termination Adjust
F. DividerAdjust
G. Meter Adjust
H. Discriminator Adjust
I. Power Overloads (Mixer CR4) Replacement
Section VII STORAGE AND SHIPMENT
A. Storage
B. Shipment
Section VIII TABLE OF REPLACEABLE PARTS
Section IX PRINTED CIRCUIT BOARD PARTS LAYOUT
A. Local Oscillator Board
B. I. F. Board
C. Pulse Network Board
D. Audio Board
Em Filter and Power Supply Board
APPENDIX I SCHEMATIC DIAGRAM | ||
![]() | ||
Start gratis downloaden | ||
Comments (1)