Equipment information

Associated Research Incorporated 4045AI Level Meter
Manufacturer:
Model:
4045AI
Date:
1987
Category:
Group:
Description:
Megohmmeter

Information

1. Wide, easily read 4-1/2 inch AC/DC kilovoltmeter with 2% of full scale accuracy. 2. Detachable 5 foot return (ground) lead. This lead is always used in performing tests and is grounded for safety. 3. Detachable 5 foot high voltage lead with flexible rubber insulation for easy handling. Control panel Jacks are well recessed for safety. 4. Lighted AC and DC indicators on the control panel which show that the High Voltage circuit Is enabled ("Power 0a") and Indicate which node of operation was selected by rotating the power switch to either the AC or DC position* 5. Lighted Breakdown and Leakage Indication. If excessive current is drawn during the Hypot* test, the yellow leakage indicator will illuminate and an audio alarm will sound. Should any arcing occur during the Hypot* test, both the yellow leakage indicator and the orange breakdown indicators will illuminate. To reset the unit, simply decrease the output voltage to zero, place the power switch Into the "Off" position and remove whatever is causing the failure from the output leads. 6. Voltage adjust knob. This control varies the High voltage from near zero to the full 5000 volts AC or 5000 volts DC. The voltage can be adjusted only when the high voltage circuit is energised. It is recommended that the voltage control be returned to zero at the end of each test. 7. Detachable 7-1/2 fooc power cord with standard coanector. 8. Line fuse accessible from the rear. "Shock, safe" fuseholder. 9. Separate AC and DC Current Trip (sensitivity) adjustments^ The current at which the Failure alarm will trip is adjustable from approximately .3 mA to 5 mA AC or 3 mA DC. Turn the controls counterclockwise to decrease the current setting and increase sensitivity. Turn them clockwise to increase the current setting and decrease sensitivity.

show more

User Manual
Manual Type:
User Manual
Pages:
13
Size:
825.90 Kbytes (845724 Bytes)
Language:
english
Revision:
Manual-ID:
Date:
1987 01 01
Quality:
Scanned document, reading partly badly, partly not readable.
Upload date:
2017 10 21
MD5:
987e1ad9da1a18996ea03dea1203041d
Downloads:
410

Information

This manual discusses the reasons why dielectric withstand Tests are required, The precautions necessary to ensure that The tests are done safely, and how such Tests are accomplished on various classes of materials, components and products. In Later chapters, the features of this Associated Research Model Hypot® are explained, along which a step by step guide Co its proper use. Finally, technical data is presented.

show more