Equipment information

Tektronix 533 Oscilloscope
Manufacturer:
Model:
533
Date:
1961
Category:
Group:
Description:

Information

General The Tektronix Type 533/533A Oscilloscopes are general purpose instruments well suited to laboratory use. Plug-In preamplifiers are used in the vertical-deflection system, permitting the instruments to be used in many specialized applications, including, among others, wide band, dual trace, low level, differential, maximum frequency response and risetime, and transistor risetime checking. Specifications listed below apply to both the Type 533 and Type 533A, except in cases that are otherwise noted. Vertical Deflection System All specifications for the Vertical Deflection System of the Type 533 and 533A Oscilloscopes depend upon the Plug-In unit used with the instrument. The following specifications are given assuming that a Type K Plug-In unit is used. Bandpass — DC to 15 me (down 3 dB :±y2 dB at 15 me). Risetime — .024 microseconds. Delay Line — Balanced network Signal Delay-—0.2 /¿sec. Horizontal Deflection System Triggering Modes—Type 533, Automatic, AC Fast, AC Slow, DC and High Frequency Sync. Type 533A, Automatic, AC Low Frequency Reject, AC, DC and High Frequency Sync. Triggering Signal Requirements Internal—a signal producing 2 mm of vertical deflection except 4 mm in automatic and DC modes. External—a signal of .2 volts to 10 volts, peak to peak. (The sweep will trigger on larger signals, but the TRIGGERING LEVEL control operates over a ± 10 volt range.) Automatic mode requires 0.4 V. Triggering Frequency Range—-triggered operation to 5 me. Synchronizing Signal Requirements Internal—-a signal producing 2cm of vertical deflection. External—a signal of 2 volts. Synchronizing Frequency Range — synchronized operation 5 me to 30 me. Sweep Rates Twenty-four position switch provides calibrated sweep rates from .1 /¿sec/cm to 5 sec/cm. Accuracy typically within 1% of full scale; in all cases within 3% of full scale. Continuously variable sweep rates are available from .1 /¿sec/cm to 12 sec/.cm Magnifier Six degrees of sweep magnification are provided; 2, 5, 10, 20, 50 and 100 times. Accuracy within 5% when the magnified sweep does not exceed the maximum calibrated rate of 0.02 microseconds/cm.

show more

Service and User Manual
Manual Type:
Service and User Manual
Pages:
125
Size:
31.49 Mbytes (33021481 Bytes)
Language:
english
Revision:
Manual-ID:
Date:
1961 01 01
Quality:
Scanned document, all readable.
Upload date:
2017 04 23
MD5:
7e4e665bd4651ba2d58f2087b384af48
Downloads:
1485

Information

Specifications Operating Instructions Applications Circuit Description Maintenance Calibration Procedure Parts List and Diagrams

show more