Equipment information
Precision Electronics 202 Signal Analyzer
Manufacturer:
No picture available!
Maybe you can upload a pic for the
Precision Electronics 202 ?
If you have any other manuals for the
Precision Electronics 202 you can upload the files here .
Model:
202
Date:
Category:
Group:
Description:
Signal Tracer
Information
New all purpose signal tracer for speedy service of Radio,
TV, Audio and Electronic H^uipment, Checfeall stages from
antenna to speaker or picture tubfc..
Tests iriisrophones, pickups^ transformers, speakers,
resistors, condensers etc.
Quickly locates intermitt^nts, open circuits, hum, noise and
distorted stages*.
Both visual and aural tracing through the supersensitive
indicator eye and built-in £ inch speaker,
RF Probe contains amplifier-detector tube for extremely high
gain and frequents» response to 300; KC,.
Audio channel has a three stage- pre-amplifier- fsatyrieg-
cascode- -cir-cui-t plus overall feedback,
Pre~araplifif3r channel is .flat from 2 CPS to 300,000 CPS
:to indicator eye or scope 'output,•
Three position attenuator provides accurate stage to stage
gain measurements. Gain control adjusts indicator eye and
speaker sensitivity only.
Speaker can. be shut off by voice coil switch.
Four position Selector Switch for selecting:
(l) RF Probe (2) Audio Probe (3) Special noise test with
applied break down voltage (it) Wattmeter circuit for
checking power consumption of set-under-test»'
Substitution test speaker and output transformer permits
direct connection to voice .ccdl -or output transformer by
means of binding posts on front panel.
Plug-In type RF Probe and Audio Probe,
TUBE COMPLEMENT
6ABU RF Amplifier^Detector (Inside Probe)
12AX7 Dual triode, 1st pre-amplifier stage, cascode connected
12AX7 Dual triode, 2nd & 3rd pre-amplifier stages
6V6GT Beam power, output pentode
6XU Full wave rectifier
6E£ Indicator Eye■
6AL5 Indicator Recifier
For use on 110-120 volts 60 cycles (off-on switch on back of
watt. control)
Signal Tracer Applications
Wattmeter
For use as a wattmeter, first set the Selector Switch to
"watts'* position. Since the Amplifier section of this
instrument is not required, reduce the
Manual Type:
Service and User Manual
Pages:
17
Size:
1.12 Mbytes (1172501 Bytes)
Language:
english
Revision:
Manual-ID:
Date:
Quality:
Scanned document, reading partly badly, partly not readable.
Upload date:
2015 03 07
MD5:
4b5c96b8160b08e6fdabfa5e112a0906
Downloads:
544