Equipment information

Electronic Navigation Industries 3100LA Amplifier
Manufacturer:
Model:
3100LA
Date:
1990
Category:
Group:
Description:
BROADBAND POWER AMPLIFIER

Information

The ENI Model 3100LA is an all solid state Amplifier which has a flat frequency response from 2 50kHz to 150MKz. it provides up to 100W of linear power with low harmonic and intermodulation distortion. Gain is 55dB nominal, with variation of less than +_1.5dB over the entire frequency range. Input and output impedance are SOohms and the unit may be driven to full power output by most RF synthesizers, signal generators and swept^signal sources. The ENI Model 3100LA will deliver its rated power output into any load impedance, regardless of match. Built-in protection circuitry will absorb the power reflected from a mismatched load without causing failure or oscillation. Output RF voltage is displayed on the front panel meter. The Model 3100LA is packaged for bench mounting and is shipped with rack mounting adapters. Its integral Power Supply and cooling operate from a 100/ 107.5/ 1150/ 120 or 200/ 125/ 230/ 240VAC 50/60HZ main supply. The Model 3100LA will raise the power level of signal sources and generators without requiring tuning or bandswitching. The Class A linear circuitry will amplify signals of AM, FM, SSB, TV and complex modulations limited only by their peak input and bandwidth, with minimum distortion.

show more

Service and User Manual
Manual Type:
Service and User Manual
Pages:
32
Size:
1.62 Mbytes (1693683 Bytes)
Language:
english
Revision:
Manual-ID:
Date:
Quality:
Scanned document, reading partly badly, partly not readable.
Upload date:
2016 01 25
MD5:
6bd2aa5021a0463e2f060a3f05c6e7c8
Downloads:
443

Information

CHAPTER 1 GENERAL INFORMATION 1-1 1.1 Introduction ... 1-1 1.2 Specifications ... 1-1 1.3 Instrument Identification ... 1-1 CHAPTER 2 PREPARATION 2-1 2.1 initial Inspection ... 2-1 2.1.1 Mechanical Check ... 2-1 2.1.2 Claim for Damage ... 2-1 2.1.3 Performance Check ... 2-1 2.2 Preparation for Use ... 2-1 2.2.1 Power Requirements ... 2-1 2.2.2 Power Cable Ground Protection ... 2-1 2.2.3 Cooling ... 2-2 2.3 Rack Mounting ... 2*2 CHAPTER 3 OPERATION 3-1 3.1 Functional Description ... 3-1 3.2 Control, Indicators and Conn. . 3-1 3.3 Operating Procedure ... 3-1 3.4 Precautions ... 3-1 CHAPTER 4 PRINCIPLES OF OPERATION 4-1 4.1 General ... 4-1 4.2.1 Driver Amplifier Module (A234) 3100LA-14401 ... 4-1 4.2.2 Power Amplifier Module (A166) 32Ö0L-4732 ... 4-1 4.2.3 Output Combiner Module (A235) 3100LA-14402 ... 4-1 4.2.4 RF Voltmeter Module (A168) 3100 LA-14403 ... 4-3 4.2.5 Power Distribution 3100 LA-12401 ... 4-3 CHAPTER 5 PERFORMANCE TEST PROCEDURES 5-1 5.1 Performance Tests ... 5-1 5.1.2 Test Equipment Required ... 5-1 5.1.3 Gain and Gain Variation Test. 5-1 5.1.3.1 Calibration of Set-Up ... 5-1 5.1.3.2 Measurement Procedure ... 5-2 5.1.4 RF Output Power Test ... 5-2 5.1.4.1 Measurement Procedure ... 5-2 Paragraph Page 5.1.5.1 Measurement Procedure ... 5-2 CHAPTER 6 TROUBLESHOOTING AND REPAIR 6-1 6.1 Troubleshooting ... 6-1 6.2 Locating Faulty RF Module .. 6-2 6.2.1 6-2 6.2.2 isolating Amplifier Problem .. 6-2 6.2.2.1 Output Combiner Test (A235) 3100 LA-14402 ... 6-3 6.2.2.2 RF Power Amplifier Module Test (A166) 3200L-4732 .. 6-3 6.2.2.2.1 Bias Voltage Check ... 6-3 6.2.2.2.2 Low Power Sweep Test ... 6-3 6.2.2.2.3 Measurement Procedure ... 6-4 6.2.2.3 Driver Amplifier Module (A234) 3100 LA-14401 ... 6-4 6.2.3 RF Voltmeter (A168) 3100LA-14403 ... 6-4 6.2.3.1 Alignment Procedure ... 6-4 6.3 DC Power Supply ... 6-4 6.3.1 General ... 6-4 6.3.2 Test Procedure ... 6-4 6,4 Disassembly Procedure ... 6-5 6.4.1 6-5 6.4.2 Tools Required ... 6-5 6.4.3 Removal of Cover ... 6-5 6.4.4 Driver Amplifier Heatsink Assembly 3100 LA-13405 . 6-5 6.4.5 Power Supply Regulator Board 3100 LA-14404 ... 6-5 6.4.6 Output Combiner Module (A235) 3100 LA-14402 ... 6-5 6.4.7 Power Amplifier Heatsink Assemblies 3100 LA-13403 & 3100LA-13404 ... 6-6 6.4.8 Power Supply Assemblies 3100 LA-13406 ... 6-6 6.4.9 Power Amplifier Module ίA166) 3200L-4732 ... .. 6-6 CHAPTER 7 SCHEMATICS AND PARTS LIST 7.1 Schematic Diagrams ... 7.2 Parts List ... 7.3 List of Manufacturers ... 7.4 Ordering Replacement Parts .

show more