Equipment information
California Instruments 101T Power supply
Manufacturer:
No picture available!
Maybe you can upload a pic for the
California Instruments 101T ?
If you have any other manuals for the
California Instruments 101T you can upload the files here .
Model:
101T
Date:
1988
Category:
Group:
Description:
Power Source
Information
The California Instruments Model 101T Power Amplifier is a
solid state, high performance, low distortion power source
that provides up to 100 VA output when used with the proper
California Instruments Oscillator. The Model 101T Power
Source is illustrated in Figure 1-1. Full power output is
available from 105 volts to 135 volts rms and from 45 Hz to
10 KHz.
For two phase and three phase operation, at least two power
amplifiers must be combined together with the applicable
multi-phase Oscillator. Two power amplifiers will provide a
total of 200 VA two-phase power, or 200 VA of three-phase
power in the open Delta configuration, Three power
amplifiers will provide 300 VA of three-phase power in the
wye configuration,
Manual Type:
Service Manual
Pages:
75
Size:
2.98 Mbytes (3127986 Bytes)
Language:
english
Revision:
R
Manual-ID:
4010-960
Date:
Quality:
Scanned document, reading partly badly, partly not readable.
Upload date:
2015 12 20
MD5:
b46b907f06e831eb90ee098b9ed02fa8
Downloads:
599
Information
GENERAL DESCRIPTION
1.1 INTRODUCTION 1
1. 2 GENERAL DESCRIPTION 1
1, 3 ACCESSORY EQUIPMENT 1
INSTALLATION AND OPERATION
2. I UNPACKING 3 2, 2 POWER REQUIREMENTS 3 2. 3 CIRCUIT
BREAKER REQUIREMENTS 4
2.4 OUTPUT VOLTAGE and METER RANGE 4
2.5 ACCEPTANCE TEST PROCEDURE 4 2, 6 MECHANICAL INSTALLATION
5 2. 7 INPUT POWER WIRING 6 2.8 OUTPUT POWER WIRING 6
2. 9 FRONT PANEL CONTROLS 6
THEORY OF OPERATION
3. 1 GENERAL 8
3. 2 DETAILED CIRCUIT DESCRIPTION 8
CALIBRATION PROCEDURE
4. 1 GENERAL 14
4. 2 TEST EQUIPMENT REQUIRED 15
4. 3 INITIAL ADJUSTMENTS 15
4. 4 AC LINE INPUT POWER and OVERLOAD
ADJUSTMENT 18
4.5 VOLTAGE, POWER OUTPUT and HARMONIC DISTORTION 18
4.6 LINE REGULATION 19
4.7 LOAD REGULATION ADJUSTMENT 19
4. 8 AMPLITUDE STABILITY 21
4. 9 FREQUENCY RESPONSE 21
4. 10 AC NOISE LEVEL 22
4. 11 0. 7 LAGGING POWER FACTOR 22
4. 12 0. 7 LEADING POWER FACTOR 23
MAINTENANCE AND TROUBLESHOOTING
5. 1 GENERAL 25
5.2 TROUBLESHOOTING 25
CIRCUIT DIAGRAM
6.1 GENERAL 26
6. 2 REFERENCE DESIGNATIONS 26
REPLACEABLE PARTS
7.1 GENERAL 31
7. 2 ORDERING INFORMATION 31
PARTS LIST
APPENDIX A
CODE LIST OF MANUFACTURERS