Equipment information

Wavetek SSI-3000B Test Set
Manufacturer:
Model:
SSI-3000B
Date:
1983
Category:
Group:
Description:
Service Monitor

Information

The Wavetek Model SSI-3000B is a compact, lightweight Service Monitor for testing FM and AM transceivers. Its low (25 lb) weight and optional inverter permit use in the field, powered by a vehicle battery. The frequency range is 400 kHz to 1000 MHz in 100 Hz steps. An audio Synthesizer permits generation of subaudible tones and timed tone bursts. In receive mode, an internal Counter displays frequency error, modulation frequency, or received sub-audible tone frequency. RF voltage level Is continuously variable from 0.03 μΝ/RMS to 316 mVRMS. An internal CRT display shows modulation waveform and relative signal strength. A meter reads modulation, SINAD (using the internal 1 kHz tone source), audio input voltage, or RF power from 1 to 100 W. The internal load eliminates the possibility of damage from accidental keying. The meter and CRT both display the same information, including SINAD, noise and distortion; however, only the meter indicates power, and only the CRT indicates relative signal strength.

show more

Service and User Manual
Manual Type:
Service and User Manual
Pages:
134
Size:
11.53 Mbytes (12095087 Bytes)
Language:
english
Revision:
Manual-ID:
Date:
Quality:
Scanned document, all readable.
Upload date:
2014 11 18
MD5:
d413226087127564daa40b059341867e
Downloads:
1649

Information

General Information 1.1 Introduction 1.2 Specifications 1.3 Options 1.4 Accessories Preparation for Use 2.1 Introduction 2.2 Unpacking and Inspection 2.3 Pre-turn On 2.4 Power Requirements 2.5 Environmental Considerations 2.6 Installing the Inverter Operation 3.1 Introduction 3.2 Front Panel Description 3.4 Initial Turn-On 3.5 RF Generator with Single-Source FM 3.6 RF Sweep 3.7 RF Generate with Multiple Source FM 3.8 RF Generate with AM 3.9 SINAD Measurements 3.10 AC Voltmeter 3.11 RF Wattmeter 3.12 CRT FM/AM Measurements 3.13 Lissajous 3.14 Relative Signal Strength 3.15 Auto Calibration Theory of Operation 4.1 Overall 4.2 A10 Front Panel Board 4.3 A11 Frequency Control Board 4.4 A3 High Frequency Synthesizer 4.5 A2 Low Frequency Synthesizer 4.6 A1 Mixer Board 4.7 A4 IF Amplifier 4.8 A5 Audio Board 4.9 A7 Deflection Board 4.10 Miscellaneous Board Maintenance 5.1 Introduction 5.2 Service and Maintenance Information 5.3 Performance Tests/Calibration 5.4 Troubleshooting *** Performance Test Record Replaceable Parts 6.1 Introduction 6.2 Manufacturers Code *** Parts Lists Schematics Application Data Performance Data Manual Changes/Options

show more